I-view FDMO-2MIP-20XIR IP SpeedDome Network Camera Manuel d'utilisateur télécharger pdf (Page 24)

compliant and not on the list. You can check the used camera support Onvif

compliant from: http://www.onvif.org. Click “ Onvif setup “ icon to setup the

parameters which you want to run on the Hybrid DVR or NVR.

 Compress: Select the suitable codec for video recording and transmission.

 Recording resolution: Select the resolution for video recording and display.

 Frame rate: Select the frame rate for video recording and display.

 Rate Control: You can choice video quality or bit rate from this tab. Good

video quality or large bit rate request bigger storage capability.

 IP address: Entry the correct IP address for the connected IP camera. If you

do not know the IP camera’s IP address, you can click “Find” icon to find out

the currently connected IP cameras

User name & Password: The user name and password must be matched the

setting of IP camera which you want to connect.

The default User name / Password is “ admin / 123456 “ and IP address is

192.168.0.123. Some special issues to cause cannot find out the IP address

that you can try the 192.168.123.123

 Find: Click this icon to find out all the currently connected IP cameras on the

list. You will find out the network information of each IP camera. Please

refer the diagram shown as above Fig A. Click the IP address and “Select”

icon, the IP camera information will be show on.

 System Firmware update: Click “System Firmware update icon” icon

to update the newest IP camera firmware; you can check and download the

newest firmware version from our website: www.i-view.com.tw .

 Change IP: Click “Change IP” icon to setup the DHCP or Static IP

address and also modify the username /Password. Please refer to Fig B

diagram. After modification, click “Change” icon to confirm the setting.

 Discover: Click “Discover” icon to research the IP address of system.

 Reboot: Click “Reboot” icon to restart this IP camera.

 Go Web: Click this icon to enable the I.E. Browser to check/setup the

detail parameters.

 Select: Choice the IP camera which you find out from the system and then

click “Select” icon to assign this IP camera into the camera channel of

Witness NVR.

 Advance setup: Click this icon will enable the detail parameters setting of IP

camera. You need to load the Active X if this NVR is activated this process at

first time.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 89 90

Pas de commentaire

I-view FDMO-2MIP-20XIR IP SpeedDome Network Camera Manuel d'utilisateur Page 24