I-view FDMO-2MIP-20XIR IP SpeedDome Network Camera Manuel d'utilisateur télécharger pdf (Page 51)

 Motion alarm: Enable Motion detection function and you can setup the

trigger schedule and detection area. Click and drag the left button of

Mouse to setup the detection and you also can select the motion sensitivity.

You can specify the linkage method (Such as Trigger alarm output, move

the PTZ camera preset position and notify via email) when an event

occurs.

 Alarm trigger: The alarm trigger almost same as Motion alarm, please

refer the description of Motion alarm section.

 Alarm interval: The trigger of alarm output will be triggered base on the

interval period.

 Recording: Click this button to setup the type of triggered recording, storage

media and schedule recording. You can setup the Pre recording & Post

recording period with the video and picture format on difference storage

device. Please refer the detail process as below:

 Recording: Enable the” Schedule” recording and you can select

“Continue recording “, “ Start recording when network failed” and

“ Schedule recording “ mode. As for the “ Start recording when

network failed” that will save the video clips on the SD card, please add

the SD card when you enable this recording mode.

 “Triggered recording”: Setup Pre/Post recording period and maximum

period is 10 seconds.

 “Recording parameters” :

Streaming ID: Select the video streaming which we want to recording.

Save mode: There are two modes “Over write when full “and “Keep

days “.

 Pre-recording: The time you set to start recording before the

scheduled time or the event. For example, if an alarm triggers

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 89 90

Pas de commentaire

I-view FDMO-2MIP-20XIR IP SpeedDome Network Camera Manuel d'utilisateur Page 51